Viking spas Destiny River Spas Owner's Manual page 21

TURBO (Whirlpool) JET / (VIKING II
ONLY) & Volcano Jet (Heritage II
only)
The Turbo jet is located on the filter cavity
wall is the Turbo jet. This jet is a combina-
tion valve and high capacity jet. To turn
the Turbo jet on, simply turn the face counter-
clockwise to the first stop position. To turn the
Turbo jet off, turn the face clockwise to bring the main jets back to full
power.*
The Volcano Jet operates on a valve
located in the middle of the lounger. Turn
the valve to activate the jet. Note: this valve
directs one of the pumps and will effect the flow
this pump used to power other jets in the spa.
* Due to the substantial amount of water pressure when the Turbo Jet
is operating, you must turn the pump to the off or low speed cycle
position before attempting to rotate the jet face.
AIR CONTROLS
Air controls are adjusted by rotating the topside dial. These controls
serve to regulate the amount of air mixed with water when the
whirlpool or hydrotherapy jets are operating in the high pump mode.
Viking I & II Only
All other models (See illus-
tration on page 14)
20