Table of Contents
Advertisement
TOPSIDE CONTROL INSTRUCTIONS
(Royale ETS, Legacy & Heritage Series)
Pump 2 Controls
Heat On
Secondary Pump,
Displays Temperature and
Indicator Light
On and Off
Diagnostic Messages
Controls Low
Turns Light
Sets Water
Speed/High Speed Pump
On/Off
Temperature
INITIAL START-UP
When your spa is first activated, it will go into a Priming mode, indi-
cated by "Pr". The Priming mode will last for less than 5 minutes.
Then, the spa will begin to heat and maintain the water temperature in
the Standard mode indicated by "St".
TEMPERATURE (80°F – 104°F / 26°C – 40°C)
The start up temperature is set at 100°F/37°C. The last temperature is
constantly displayed on the LCD.
Note:
The last spa temperature displayed is current only
when the pump has been running for at least 2 minutes.
Press the "Temp" button to display the temperature previously set. The
set temperature flashes on the display. Pressing the "Temp" button a
second time, while it is still flashing, will cause the set temperature to
increase or decrease depending on what direction was last chosen.
Each press to follow will change the set temperature in the same direc-
tion. If the opposite direction is desired, release the pad and let the
display revert to the actual water temperature. Press the button to dis-
play the set temperature, and press again to make the temperature
change in the desired direction. After three seconds, the LCD will
stop flashing and display the current spa temperature.
16
Hide quick links:
Advertisement
Table of Contents
