Example 2: Serial Port To Master Device - ABLELink MB5000 Series User Manual

User manual Version 1.0
Modbus Gateway
Then we will configure the ID Routing between ID 1-10 of Port1 and ID 1-10 of Port2, where the Master ID
1-10 will be routed to Port1 and Master ID 11-20 will be routed to Port2 as below:
Enter Master ID 11-20
Enter Slave ID 1-10
Click to add to the ID list.
After all settings are configured click and then click to immediately
apply the changes.

Example 2: Serial Port to Master Device

Two serial ports connecting to different serial Master devices, where Port1 uses RS485 communication and
Port2 uses RS422 communication. Modbus Gateway uses Ethernet to connect to the remote Ethernet Slave
Device, and the two Master serial ports are connected to the slave devices through the Modbus Gateway as
indicated below.