Configuration Examples; Example 1: Serial Port To Slave Device; Port1 Settings; Configure The Port Parameters - ABLELink MB5000 Series User Manual

User manual Version 1.0
Modbus Gateway

Configuration Examples

Example 1: Serial Port to Slave Device

Two serial ports connecting to different serial devices, where Port1 connects to 10 serial Modbus RTU
devices with ID 1-10 using RS485 communication; and Port2 connects 10 serial Modbus ASCII devices with
ID 1-10 using RS422 communication. Two computers are used to access the Master device as indicated
below.

Port1 settings:

Configure the port parameters:

Port1 uses RS485 and should be set in the Hardware Mode option. Click after settings are
made but do not click Apply until Port2 has been configured.