Port2 Settings; Configure The Port Parameters - ABLELink MB5000 Series User Manual

User manual Version 1.0
Modbus Gateway
Then we will configure the ID Routing between ID 1-10 of Port1 and ID 1-10 of Port2, where the Master ID
will be used to identify the routing between Port1 and Port1. In this example, the Master ID1-10 is routed to
Port1 and Master ID11-20 is routed to Port2. Port1 settings are as below:
Enter Master ID 1-10
Enter Slave ID 1-10
Click to add to the ID list.
After all settings are configured click but do not click "Apply" until Port2 has been
configured.

Port2 settings:

Configure the port parameters:

Port2 uses RS422 and should be set in the Hardware Mode option. Click after settings are
made but do not click Apply until Port2 has been configured.