Electronic Oven Control; Oven Indicator Lights; Display; Start/Enter - Whirlpool GAS RANGE Use & Care Manual

A
I H
K J
A. Oven display
B. Clock
C. Timer/cancel
D. Start/enter (control lock)
E. Auto clean
F. Off/cancel

Oven Indicator Lights

The indicator lights are located along all 4 sides of the display.
The indicator lights light up or flash when the oven is in one of the
following modes: Bake, Broil, Clean (on some models), On,
Start?, Controls Locked, Door Locked (on some models), Delay,
Timer, Temp, Cook Time, or Start Time.

Display

When power is first supplied to the range, "PF" or a flashing time
will appear on the display. Press OFF/CANCEL to clear.
If "PF" or a flashing time appears at any other time, a power
failure has occurred. Press OFF/CANCEL and reset the clock if
needed.
When the oven is in use, the display shows preheat time or oven
temperature setting.
When the oven is not in use, the display shows the time of day.
When using Start Time/Cook Time, the display will show either
hours and minutes, or minutes and seconds.
If Start/Enter is not pressed after setting a function, the "Start?"
oven indicator light will begin flashing after 5 seconds.
8

ELECTRONIC OVEN CONTROL

B C D E F
G
G. Temperature/time
H. Cook time
I. Start time
J. Custom broil
K. Bake

Start/Enter

The Start/Enter pad begins any oven function. If the Start/Enter
pad is not pressed within 5 seconds after pressing a function
pad, the "Start?" indicator light will flash as a reminder.
If Start/Enter is not pressed within 1 minute after pressing a
function pad, the oven display will return to the time of day mode
and the programmed function will be canceled.

Off/Cancel

The Off/Cancel pad stops any function except the Clock, Timer
and Control Lock.
The cooling fan may continue to operate after an oven function
has been canceled, depending on oven temperature.
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
Before setting, make sure the oven and Timer are off.
1. Press CLOCK.
2. Press the TEMP/TIME "up" or "down" arrow pad to set the
time of day.
3. Press START/ENTER or CLOCK.
Tones are audible signals, indicating the following:
One tone
Valid pad press
Oven is preheated (long tone)
Function has been entered
Reminder, repeating each minute after the end-of-cycle tones
Three tones
Invalid pad press
Four tones
End of cycle

Fahrenheit and Celsius

The temperature is preset at Fahrenheit, but can be changed to
Celsius on some models.
To Change: Press and hold CUSTOM BROIL for 5 seconds. A
tone will sound, and "°C" will appear on the display. Repeat to
change back to Fahrenheit. To exit mode, press OFF/CANCEL.

Clock

Tones