Seat - Husqvarna LT120 Owner's Manual

• First connect RED battery cable to positive (+) terminal
with hex bolt, flat washer, lock washer and hex nut as
shown. Tighten securely.
• Connect BLACK grounding cable to negative (-) termi-
nal with remaining hex bolt, flat washer, lock washer
and hex nut. Tighten securely.
• Close battery box door.
Open battery box door for:
• Inspection for secure connections (to tighten hard-
ware).
• Inspection for corrosion.
• Testing battery.
• Jumping (if required).
• Periodic charging .
DISCARD
TERMINAL
PROTECTIVE
CAPS
POSITIVE
(RED) CABLE

SEAT

PAN
BATTERY
BOX DOOR
INSTALL SEAT (See Fig. 4)
Adjust seat before tightening adjustment bolt.
• Remove cardboard packing on seat pan.
• Place seat on seat pan and assemble shoulder bolt.
• Assemble adjustment bolt, lock washer and flat washer
loosely. Do not tighten.
• Tighten shoulder bolt securely.
• Lower seat into operating position and sit on seat.
• Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way
down.
• Get off seat without moving its adjusted position.
• Raise seat and tighten adjustment bolt securely.
ASSEMBLY
LOCK
HEX
WASHER
NUT
FLAT
WASHER
HEX
BOLT
NEGATIVE
(BLACK) CABLE
FIG. 2
FIG. 3
SEAT PAN
SHOULDER
BOLT
ADJUSTMENT
BOLT
INSTALL MULCHER PLATE (See Figs. 5 and
6)
CAUTION: Do not remove discharge
guard from mower. Raise and hold
guard when attaching mulcher plate
and allow it to rest on plate while in
operation.
Raise and hold deflector shield in the upright position.
Position alignment cup over rear baffle.
Pivot mulcher plate forward and hook on mounting bolt.
Be sure hang tab hooks top of deck opening.
Assemble flat washer, lock washer and wing nut to
mounting bolt and tighten securely.
DEFLECTOR
SHIELD
REAR
BAFFLE
7
SEAT
FLAT WASHER
LOCK WASHER
FIG. 4
MOUNTING
BOLT
MULCHER
PLATE
FASTENING
TAB SLOT
ALIGNMENT
CUP
FIG. 5