Throttle Control Cable; Engine; Fuse - Husqvarna LT120 Owner's Manual

SERVICE AND ADJUSTMENTS
POSITIVE TERMINAL
CHASSIS
POSITIVE TERMINAL
TO REPLACE HEADLIGHT BULB
• Raise hood.
• Pull bulb holder out of the hole in the backside of the
grill.
• Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
• Check wiring. See electrical wiring diagram in the
Repair Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 30)
• Raise hood.
• Unsnap headlight wire connector.
• Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
• To replace, reverse above procedures.
NEGATIVE TERMINAL
CABLES
CHARGED
BATTERY
NEGATIVE TERMINAL
FIG. 29

ENGINE

TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 31)
The throttle control has been preset at the factory and
adjustment should not be necessary. Check adjustment as
described below before loosening cable. If adjustment is
necessary, proceed as follows:
• With engine not running, move throttle control lever
from slow ( ) to choke (
lever from choke (
• Check that holes "A" in governor control lever and hole
in governor plate line-up. If holes "A" are not aligned,
loosen clamp screw and move throttle cable until holes
are aligned. Tighten clamp screw securely.
GOVERNOR
CONTROL LEVER
HOLES "A"
22
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 30
) position. Slowly move
) to fast ( ) position.
GOVERNOR
CONTROL PLATE
CLAMP
THROTTLE
SCREW
CABLE
FIG. 31