Troubleshooting Chart - Husqvarna LOGTH2448T Operator's Manual

TROUBLESHOOTING CHART:

See ap pro pri ate section in manual un less di rect ed to a service center
PROBLEM
Will not start
Hard to start
Engine will not
turn over
Engine clicks but
will not start
Loss of power
CAUSE
1. Out of fuel.
2. Engine not "CHOKED"
properly.
3. Engine fl ooded.
4. Bad spark plug.
5. Weak or dead battery.
6. Dirty air fi lter.
7. Dirty fuel fi lter.
8. Water in fuel.
9. Loose or damaged wiring.
10. Carburetor out of adjustment. 10. See "To Adjust Carburetor"
11. Engine valves out of
adjustment.
1. Dirty air fi lter.
2. Bad spark plug.
3. Weak or dead battery.
4. Dirty fuel fi lter.
5. Stale or dirty fuel.
6. Loose or damaged wiring.
7. Carburetor out of adjustment. 7. See "To Adjust Car bu re tor" in
8. Engine valves out of
adjustment.
1. Brake pedal not depressed.
2. At tach ment clutch is engaged. 2. Disengage attachment clutch.
3. Weak or dead battery.
4. Blown fuse.
5. Corroded battery terminals.
6. Loose or damaged wiring.
7. Faulty ignition switch.
8. Faulty solenoid or starter.
9. Faulty operator presence
switch(es).
1. Weak or dead battery.
2. Corroded battery terminals.
3. Loose or damaged wiring.
4. Faulty solenoid or starter.
1. Cutting too much grass/too
fast.
2. Throttle in "CHOKE" position. 2. Adjust throttle control.
3. Build-up of grass, leaves and 3. Clean underside of mower
trash under mower.
4. Dirty air fi lter.
5. Low oil level/dirty oil.
CORRECTION
1. Fill fuel tank.
2. See "TO START ENGINE" in
Operation section.
3. Wait several minutes before
attempting to start.
4. Replace spark plug.
5. Recharge or replace battery.
6. Clean/replace air fi lter.
7. Replace fuel fi lter.
8. Empty fuel tank and carbure-
tor, refi ll tank with fresh gas-
oline and replace fuel fi lter.
9. Check all wiring.
in Service and Adjustments
section.
11. Contact a qualifi ed service
center.
1. Clean/replace air fi lter.
2. Replace spark plug.
3. Recharge or replace battery.
4. Replace fuel fi lter.
5. Empty fuel tank and refi ll tank
with fresh, clean gasoline.
6. Check all wiring.
Service and Adjustments
section.
8. Contact a qualifi ed service
center.
1. Depress brake pedal.
3. Recharge or replace battery.
4. Replace fuse.
5. Clean battery terminals.
6. Check all wiring.
7. Check/replace ignition switch.
8. Check/replace solenoid or
starter.
9. Contact a qualifi ed service
center.
1. Re charge or replace battery.
2. Clean battery terminals.
3. Check all wiring.
4. Check/replace solenoid or
starter.
1. Raise cutting height/reduce
speed.
housing.
4. Clean/replace air fi lter.
5. Check oil level/change oil.
28