Husqvarna GTT348 Owner's Manual page 7

5
LOWER CHUTE (See Fig. 5)
1. Raise and hold defl ector shield in upright position.
2. Place slot in lower chute over tab on mower and position
lower chute over mower opening as shown.
3. Hook rear latch into fl ange hole on back of mower.
4. Hook front latch into tab hole on front of mower.
CAUTION: Do not remove defl ector
shield from mower. Raise and hold
shield when attaching lower chute
and allow it to rest on chute while in
operation.
DEFLECTOR
SHIELD
TAB
OPTIONAL FRONT
GAUGE WHEEL
FRONT
LATCH
REAR LATCH
FIG. 5
6
UPPER CHUTE (See Figs. 6A & 6B)
1. Lower mower to its lowest cutting position.
2. Assemble upper chute by inserting curved end into
hole in back of cover.
NOTE: Handle carefully so as not to damage full bagger
indicator.
3. Push in and turn upper chute until it is in line with lower
chute.
4. Align the bosses on lower chute with alignment slots
on upper chute and slide together.
5. Secure with rubber latch by hooking hole in latch over
latch pin.
UPPER
COVER
CHUTE
7
LEVEL MOWER
• Be sure mower is properly leveled for best mower
per for man ce. See your tractors owner's manual for
ins truc tions
7
FULL BAGGER
INDICATOR
HANDLE
LOWER
CHUTE
FIG. 6A
ALIGNMENT
SLOT
LATCH PIN
RUBBER
LATCH
BOSSES
FIG. 6B