Schematic Diagram -Main (1/2) Section - Sony XR-4880 Service Manual

• Waveforms
1
2.8Vp-p
18.432MHz
IC501 !™ OSC2
2
5.0Vp-p
32.768MHz
IC501 !§ XO
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1 / W or less unless otherwise
4
specified.
• : internal component.
¢
• C : panel designation.
• U : B+ Line.
• Power voltage is dc 14.4V and fed with regulated dc power
supply from ACC and BATT cords.
• Voltage and waveforms are dc with respect to ground
under no-signal conditions.
no mark : FM
< > : TAPE PLAYBACK
∗
: Impossible to measure
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal production
tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production
tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: FM
f
: AM (MW)
E
: TAPE PLAYBACK
6-2. SCHEMATIC DIAGRAM — MAIN (1/2) SECTION —
• Refer to page 17 for IC Block Diagrams.
• Refer to page 29 for IC Pin Function Description.
A (OFF) → B (ON)
– 21 –
(FL)
(Page 23, 24)
– 22 –
XR-4880
FAE342-E01