Install Mower And Drive Belt - Husqvarna GTH2350 Owner's Manual

INSTALL MOWER AND DRIVE BELT

(See Figs. 5 and 6)
Be sure tractor is on level surface and mower suspension
arms are raised with attachment lift control. Engage parking
brake.
• Cut and remove ties securing anti-sway bar and belts.
Swing anti-sway bar to left side of mower deck.
• Slide mower under tractor with deflector shield to right
side of tractor.
IMPORTANT: CHECK BELT FOR PROPER ROUTING IN
ALL MOWER PULLEY GROOVES.
• If equipped, turn height adjustment knob counterclock-
wise until it stops.
• Lower mower linkage with attachment lift control.
• Install belt into electric clutch pulley groove.
• Place the suspension arms on inward pointing deck
pins. Retain with double loop retainer spring with loops
down as shown.
• Install front plate assembly to tractor suspension brack-
ets and retain with single loop retainer springs as
shown.
• Position front plate assembly between front mower
brackets. Raise deck and plate assembly to align holes
and insert flanged pins. Secure pins with double loop
DOUBLE LOOP
RETAINER
SPRING
SHOULDER
GAUGE
BOLT
WHEEL
3/8
WASHER
3/8-16
CENTER
LOCKNUT
USE PLIERS FOR
RETAINER SPRINGS
ASSEMBLY
CHASSIS
BRACKET
IDLER
PULLEY
DOUBLE
LOOP
RETAINER
SPRING
ANTI-SWAY
BAR
DOUBLE LOOP
RETAINER SPRING
(INWARD POINTING
DECK PINS)
LOOP
DOWN
retainer springs between the plate and mower brackets.
NOTE: To assist in locating hole in flanged pin, the hole in
pin is inline with notch on head of pin. If necessary, move
mower side-to-side to give space between plate and mower
brackets.
IMPORTANT: CHECK BELT FOR PROPER ROUTING IN
ALL MOWER PULLEY GROOVES.
• Connect anti-sway bar to chassis bracket under left
footrest and retain with double loop retainer spring.
• If equipped, turn height adjustment knob clockwise to
remove slack from mower suspension.
• Raise deck to highest position.
• Assemble gauge wheels as shown using long shoulder
bolts, 3/8 washers, and 3/8-16 center locknuts. Tighten
securely.
• Adjust gauge wheels before operating mower as shown
in the Operation section of this manual.
FRONT SUSPENSION
BRACKETS
SUSPENSION
FRONT
ARMS
MOWER
BRACKET
FIG. 5
8
ELECTRIC CLUTCH
PULLEY
FRONT PLATE
ASSEMBLY
SINGLE
LOOP RETAINER
SPRINGS
DEFLECTOR
SHIELD