Table of Contents
Advertisement
TO ATTACH NOSE ROLLER (See Fig. 4)
•
Assemble brackets "A" and "B" to the inside of mower
mounting brack ets as shown. Tighten securely.
NOTE: Be sure bracket tabs are po si tioned in tab holes
in mower brackets.
•
Position nose roller between brackets and install rod
and retainer spring.
TAB
HOLE
"A"
BRACKET
02612
RETAINER SPRING
ASSEMBLE GAUGE WHEELS TO MOWER
DECK (See Fig. 5)
The gauge wheels are designed to keep the mower deck
in proper position when operating mower. Be sure they
are properly adjusted to ensure optimum mower perfor-
mance.
•
Slide gauge wheel bar down into bracket channel, Be
sure that gauge wheel bar aligning holes are on top.
As sem ble gauge wheels as shown using shoulder bolts,
3/8 washers and 3/8-16 center locknuts and tighten
securely.
•
For ease of mower to tractor assembly, raise gauge
wheels to highest position and retain with clevis pins
and spring retainers.
•
Adjust gauge wheels before operating mower. See "TO
ADJUST GAUGE WHEELS" in the Operation sec tion
of this manual.
RETAINER SPRING
PIN
SHOULDER
AD JUST ING
BOLT
BAR
GAUGE
WHEEL
3/8 WASH ER
ASSEMBLY
HEX
LOCK
BOLT
ROD
NUT
"B"
BRACKET
NOSE
ROLLER
FIG. 4
3/8-16 CENTER
LOCKNUT
FIG. 5
INSTALL MOWER
(See Figs. 6 and 7)
Be sure tractor is on level surface and mower suspen-
sion arms are raised with attachment lift control. Engage
park ing brake.
•
Cut and remove ties securing anti-sway bar and belts.
Swing anti-sway bar to left side of mower deck.
•
Slide mower under tractor with defl ector shield to right
side of tractor.
IMPORTANT: Check belt for proper routing in all mower
pulley grooves.
•
If equipped, turn height ad just ment knob coun ter -
clock wise until it stops.
•
Lower mower linkage with attachment lift control.
•
Install belt into electric clutch pulley groove.
•
Place the suspension arms on outward pointing deck
pins. Retain with double loop re tain er spring with loops
up as shown.
•
Install front plate assembly to tractor suspension
brack ets and retain with single loop retainer springs
as shown.
•
Position front plate assembly between front mower
brack ets. Raise deck and plate assembly to align holes
and insert fl anged pins. Secure pins with double loop
retainer springs between the plate and mower brack-
ets.
NOTE: To assist in locating hole in fl anged pin, the hole
in pin is inline with notch on head of pin. If necessary,
move mower side-to-side to give space between plate and
mower brackets.
IMPORTANT: Check belt for proper routing in all mower
pulley grooves.
•
Connect anti-sway bar to chassis bracket under left
foot rest and retain with double loop retainer spring.
•
If equipped, turn height adjustment knob clock wise to
remove slack from mower sus pen sion.
•
Raise deck to highest position.
•
Adjust gauge wheels before op er at ing mower as shown
in the Operation section of this manual.
8
AND DRIVE BELT
Hide quick links:
Advertisement
Table of Contents
