Duratrax Evader EXT Assembly And Operation Manual page 13

Spring
Pin Hole
22
11
X
X
10
1. Place one of the 10x16mm bushings (110) on the bushing mounts on the diff gear case (18) and the diff gear case cover (12).
2. Install the outdrives (10) through the diff gear case and the gear cover, and install the spring pins (11) into their spring pin holes.
3. Align the keyed section of the large planetary gears (13) on the spring pins that are now installed in the outdrives.
4. Center the diff cross pin B (19) through the opening in the diff cross pin A (15) and install one small planetary gear (14) onto each end of both diff
cross pins.
5. Place the planetary gear and diff shaft assembly into the diff gear case.
6. Place a small amount of gear grease on the planetary gears that were installed in the large diff half. Rotate the gears to spread the grease evenly,
there should be enough to evenly coat each tooth of all the gears, add or remove grease as needed.
7. Install the diff gear case cover in to the diff gear case and secure it with the four 2.5x5.25mm fl at heads screws (X).
8. Install one dogbone spring into each open end of the outdrives.
G
G
P
G
Note: When installing the bushings, make sure they are fully seated. If the bushings are not
fully seated the gearbox halves may not properly fi t together or may cause binding.
1. Install a 5x10mm bushing (108) into the upper hole of the left gearbox half (20).
2. Install the top shaft (83) into the 5x10mm bushing that was just installed into the left gearbox half.
3. Install a 5x11mm bushing (109) into each side of the idler gear (17).
4. Install the idler gear shaft (89) into the idler gear bushings.
5. Install the idler gear into the left gearbox half.
6. Install the assembled differential into the bottom hole in the left gearbox half.
7. Install the two gearbox halves together. Make sure they seat together properly.
8. Secure the two halves together with the 3x12mm round head screw (D).
9. Install the 2x10mm spring pin (116) into the top shaft.
10. Install the gearbox dust cover (7) onto the right side gear box half (21).
11. Install the motor plate (96) on the side of the gearbox and attach it with the three 3x25mm round
head screws (G) and 3mm spring washers (P).
X
X
13
110
12
D
P
108
P
109
20
Differential
Gearbox
14
14
19
Keyed
Section
15
13
14
14
Differential
83
116
108
17 89
109
21
13
Bushing
Mount
Spring
11
Pin Hole
110 10
18
7
16
22