Chrysler 300 2011 Owner's Manual page 227

1. Place the ignition in the RUN position.
2. Place the handheld transmitter 1 to 3 in (3 to 8 cm)
from the HomeLink buttons while keeping the EVIC
display in view.
For optimal training, point the battery end of the hand-
held transmitter away from the HomeLink .
3. Simultaneously, press and hold both the chosen
HomeLink button and the handheld transmitter button
until the EVIC display changes from "CHANNEL #
TRAINING" to "CHANNEL # TRAINED."
Then release both the HomeLink and handheld trans-
mitter buttons.
If the EVIC display states "DID NOT TRAIN" repeat
Step 3. If the signal is too weak, replace the battery in the
handheld transmitter.
It may take up to 30 seconds or longer in rare cases. The
garage door may open and close while you train.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 225
NOTE: Some gate operators and garage door openers
may require you to replace Step 3 with procedures noted
in the "Gate Operator/Canadian Programming" section.
4. Press and hold the just-trained HomeLink button. If
the channel has been trained, the EVIC display will now
state "CHANNEL # TRANSMIT."
If the EVIC display still states "CHANNEL # TRAIN-
ING" repeat Step 3.
NOTE: After training a HomeLink
garage door does not operate with HomeLink and the
garage door opener was manufactured after 1995, the
garage door opener may have rolling code. If so, proceed
to Step 5.
5. Programming A Rolling Code System
At the garage door opener motor (in the garage), locate
the "Learn" or "Training" button.
3
channel, if the