List Of Materials; Electrical Requirements - Electrolux E30WV60PPS Installation, Use & Care Manual

List of Materials

CAUTION!
Remove carton carefully. Wear gloves to protect
against sharp edges.
Parts supplied with unit for the installation
• Hood canopy assembly with blower.
• Lamp already installed.
• Transition (3 ⁄ " x 10" rectangular)
1
4
•
Grease filter.
• Hardware bag with:
•
Use and Care / Installation Manual
• 3- 4x8 screws (to assemble Transition)
• 6- 4,5x13 screws
•
4- 10x50 screws
• Torx 20 Adapter
Remove the protective film covering the product be-
fore putting into operation.
Tools/Materials required
•
Wire nuts
• Metal duct length to suit installation
• ⁄ " Romex wire connector
1
2
•
Measuring tape
• Pliers
•
Gloves
• Knife
• Safety glasses
• Electric drill with ⁄ " and
5
16
• Spirit level
•
Duct tape
• Screwdrivers:
•
Phillips (Posidrive) #2
• Torx # 2
• Wire cutter/stripper
•
Masking tape
• Hammer
•
Saw, jigsaw or reciprocating saw
List of materials- Electrical & Installation
⁄ " Bits
3
8

Electrical Requirements

Observe all governing codes and ordinances.
Ensure that the electrical installation is adequate and
in conformance with National Electrical Code, ANSI/
NFPA 70 (latest edition), or CSA Standards C22.1-
94, Canadian Electrical Code, Part 1 and C22.2 No.
0-M91 (latest edition) and all local codes and ordi-
nances.
If codes permit and a separate ground wire is used, it
is recommended that a qualified electrician determine
that the ground path is adequate.
A copy of the above code standards can be obtained
from:
National Fire Protection Association
One Batterymarch Park
Quincy, MA 02269
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
• A 120 volt, 60 Hz., AC only, 15-amp, fused
electrical circuit is required.
• If the house has aluminum wiring, follow the
procedure below:
1. Connect a section of solid copper wire to the
pigtail leads.
2. Connect the aluminum wiring to the added
section of copper wire using special co
nectors and/or tools designed and UL listed
for joining copper to aluminum.
Follow the electrical connector manufacturer's recom-
mended procedure. Aluminum/copper connection
must conform with local codes and industry accepted
wiring practices.
• Wire sizes and connections must conform with
the rating of the appliance as specified on the
model/serial rating plate.
The model/serial plate is located behind the filter
on the top wall by the electrical box.
• Wire sizes must conform to the requirements of
the National Electrical Code, ANSI/NFPA 70 (la
est edition), or CSA Standards C22. 1-94,
Canadian Electrical Code, Part 1 and C22.2
No. 0-M91 (latest edition) and all local codes and
ordinances.
requirements
5