To Install Bagger Full Lever/Paddle; To Install Bagger Cover Panel; To Install Bagger Component To Tractor - Husqvarna CTH126 Instruction Manual

2

TO INSTALL BAGGER FULL LEVER/PADDLE

• Before installation, tractor engine must be shut off and
parking brake engaged.
• Standing behind the tractor with the bagger removed from the
backplate (1), identify the bag full switch (2) area. (See Fig 1)
2
1
Fig. 1
FRONT OF TRACTOR
3
Fig. 2
• Take bagger full lever (3) and insert tab(4) into upper slot and
rotate until lever (3) snaps into position (See Figs. 2 and 3)
• For the heaviest/wet grasses, do not attach paddle (5).
• For lighter grasses use the paddle (5) on setting "1", "2", or
"3" ("3" being for the lightest or dry grass).
• Choose your setting and rotate the bagger paddle (5) so that
the desired number (setting) faces you.
• Place paddle (5) on lever (3) so that tab (6) at the bottom of
the bagger full lever (3) goes through appropriate rectangular
slot and make sure holes in bagger full lever (3) and paddle
(5) line up.
• Feed screw (7) through bagger full paddle (5) and lever (3)
holes and fasten using nut (8) (See Fig. 3)
• Setting may be changed by loosening fasteners (7 and 8),
removing/rotating paddle (5), and tightening again.

TO INSTALL BAGGER COMPONENT TO TRACTOR

1
2
1
• Before installation, tractor engine must be shut off and
parking brake engaged.
• Install latch springs (1) in mounting holes on back plate.
• Insert hex bolt (2) through each latch spring hole and
corresponding hole in back plate.
• Fasten lock nut (3) to bolt on the other side of back plate.
4
5
4
3
7
2
6
Fig. 3

TO INSTALL BAGGER COVER PANEL

• Install bagger cover panel (1) by angling plastic posts at front
of cover panel (1) into corresponding slots at the front of the
bagger top.
• Swing back end of cover panel (1) down until it rests on
bagger cover.
• Slide whole bagger cover panel (1) rearwards so that teeth
under the opening in the cover panel slide into the teeth in
the handle portion of the bagger cover.
8
• Apply push nuts (2) to plastic posts to secure cover panel (1)
in the front.
• Secure rear side of cover panel (1) to bagger top, and fasten
by threading two screws (3) up through rear bagger top
handle into the cover panel (1).
1
3
26
1
3
1
1
2