Aegis Padlock Keypad Panel; First Time Use - Apricorn Aegis Padlock SSD User Manual

Aegis Padlock Keypad Panel

2

First Time Use

Before the Padlock can be used, the Admin PIN MUST be set. The LED will display
Solid BLUE and Solid
To Set-up the Admin PIN:
1. Press UNLOCK + 9. The LED will change to Solid
2. Enter the new Admin PIN and press UNLOCK key. If accepted the
will flash for 3 short blinks, then return to Solid
3. Re-enter the Admin PIN and press the UNLOCK key. If accepted the
LED will be Solid for 3 seconds.
4. LED will then turn
LOCK key is pressed, will return the drive to a standby state.
5. The Admin PIN is now set and will allow access to the drive or the Admin features.
6. To UNLOCK the drive, exit Admin by pressing the LOCK button. Then enter the
new PIN and press UNLOCK.
*Note: PINs must be a minimum length of 7 maximum 16 digits.
Cannot contain all consecutive numbers (2345678 or 9876543)
Cannot contain all same number (1111111)
1
GREEN to indicate the Padlock is waiting for a PIN to be set.
BLUE and remain in Admin mode for 30 seconds or if the
1
UNLOCK button
3
2
LOCK button
3
LED Indicator lights
When you first plug in the SSD
Padlock, the unit will do a self-test
to verify all security components
are working properly. The LEDs
will go through 3 test stages
RED, GREEN, and BLUE. This
will be followed by three
flashes on a successful test. Any
test failure will leave the unit in an
interoperable state with the
LED flashing.
BLUE and Blinking GREEN.
BLUE and Blinking GREEN.
GREEN
RED
GREEN LED
GREEN
7