Table of Contents
Advertisement
Program Lines:
(In RPN mode)
θ
Checksum and length: 8C82 66
Flags Used:
None.
Program Instructions:
1. Key in the program routines; press
t
2. Press
transformation.
3. Key in the x–coordinate of the origin of the new system M and press
4. Key in the y–coordinate of the origin of the new system N and press
5. Key in the rotation angle T and press
6. To translate from the old system to the new system, continue with step 7. To
translate from the new system to the old system, skip to step 12.
File name 33s-E-Manual-1008-Publication(1st).doc
Printed Date : 2003/10/8
Prompts for and stores V.
Pushes V up and recalls U.
Pushes U and V up and recalls T.
Sets radius to 1 for the computation of sin(T) and cos(T).
Calculates cos(T) and sin(T).
Calculates U cos(T) –V sin(T) and U sin(T) + V cos(T).
Pushes up previous results and recalls N.
Pushes up results and recalls M.
Completes calculation by adding M and N to previous
results.
Stores the x–coordinate in variable X.
Swaps the positions of the coordinates.
Stores the y–coordinate in variable Y.
Swaps the positions of the coordinates back.
Halts the program to display X.
Halts the program to display Y.
Goes back for another calculation.
Å
D to start the prompt sequence which defines the coordinate
Size : 13.7 x 21.2 cm
Description
when done.
¥
.
Mathematics Programs
Page : 386
¥
.
¥
15–35
Advertisement
Table of Contents
