Lubrication Recommendations - Polaris Universal ATV 2000 Owner's Safety And Maintenance Manual

Lubrication Recommendations

Item Lube Rec.
1. Engine Oil Polaris Fill oil tank. See page 47.
(2-Cycle) Injection Oil
2.Engine Oil Polaris Pre- Add to proper level on dipstick.
(4-Cycle) mium 4 Syn- See page 49.
thetic 0W40
3. Brake Fluid DOT 3 Only Maintain level between fill lines.
See page 39.
4. Transmission Polaris Pre- Add to FULL level on dipstick or
Oil mium Syn- fill to bottom of the filler hole,
thetic gear whichever is applicable.
case lube
5. Front Gear- GL 80-90 Fill to bottom thread of filler hole.
case Oil Weight Gear Make certain machine is on level
Lube surface.
6. Front Prop Grease+ Locate Fittings and Grease
Shaft U-joints
7. Front Prop- Grease+ Locate fittings and grease - - 3
shaft Yoke pumps maximum
8. Drive Chain(s) O-Ring chain Lubricate as often as required.
lube or Before each ride in wet conditions
SAE 80/90
9. Demand 4 Premium Remove set screw in hubs. Ro-
Hubs - All Hub Lube tate wheels to 4 O'clock position.
Wheel Drive If lubricant is not visible add more.
ATVs Reinstall set screw.
10. Front Drive Grease+ Locate grease fitting and grease
Axle (U Joint) with grease gun.
(AWD Mod
els)
11. Ball Joint Grease** Locate fitting on back side of
struts and grease with grease
gun.
12. Rear Gear GL 80-90 Fill to bottom of the fill hole.
Case Weight Gear
Lube
MAINTENANCE
Method Frequency*
As needed,
when refueling
Check level dai-
ly.
As required;
change every
two years or 200
hours
Change annually
or at 100 hours
Change annually
or at 100 hours
Every 3 months
or 50 hours
Every 3 months
or 50 hours
As required
Annually or at
100 hrs
Every 3 months
or 50 hours
Every 3 months
or 50 hours
Change annually
or at 100 hours
82