Deck Belt - Husqvarna 966061101 Operator's Manual

Deck Belt

Deck Belt Removal
Park on a level surface. Apply park brake. Lower the
deck into the lowest cutting position.
1. Remove foot plate and belt shields.
2. Remove any dirt or grass that may have
accumulated around the cutter housings and
entire deck surface.
3. With a ½" breaker bar and using the square
opening in the idler arm, shift the arm counter
clockwise to relieve the tension on the belt.
4. Carefully roll the belt over the top of the cutter
housing pulleys.
5. Remove the belt guide hardware with a ½"
wrench and set belt guide aside.
6. Remove the belt from around the electric clutch
on the engine shaft.
Deck Belt Installation
NoTE: For ease in installing the deck belt, refer to the
routing decal on the cutting deck.
1. Place the belt around all the pulleys except the
center spindle pulley.
2. With a ½" breaker bar, shift the idler arm counter
clockwise. When there is enough slack, slip the
belt onto the center spindle pulley.
3. Reinstall the belt guide removed in Step 5
above.
46
maINTeNaNCe
Release the belt tension
Remove belt guide
Refer to belt routing decal
8065-040
8065-045
8065-047