Kenmore 415.16537900 Use And Care Manual page 28

Hide thumbs Also See for 415.16537900:
Table of Contents

Advertisement

Troubleshooting - Electronic Ignition
Problem (Ignition)
Possible Cause
SECTION I
No sparks appear at
•Battery not installed
any electrodes when
control knob turned to
; no noise can be
•Dead battery.
heard from spark
module.
•Button assembly not
•Faulty spark module.
SECTION II
•Output lead
No sparks appear at
any electrodes when
control knob turned to
; noise can be
heard from spark
module.
SECTION III
•Output lead
Sparks are present
but not at all
electrodes and/or not
•Electrical arc between
at full strength
output wires and grill
frame.
•Weak battery.
•Electrodes are wet.
•Electrodes cracked or
28 • 464324009
Check Procedure
•Check battery orientation.
properly.
•Has battery been used
previously?
•Check to insure threads are
installed properly.
properly engaged. Button
should travel up and down
without binding.
•If no sparks are generated
with new battery and good
wire connections, module is
faulty.
•Are output connections on
connections not
and tight?
connected.
•Are output connections on
connections not
and tight?
connected.
•If possible, observe grill in
dark location. Operate
ignition system and look for
arcing between output wires
and grill frame.
•All sparks present but weak
or at slow rate.
•Has moisture accumulated
on electrode and/or in burner
ports?
•Inspect electrodes for
broken; sparks at
cracks.
electrode crack.
Prevention/Solution
•Install battery (make sure that "+" and "–"
connectors are oriented correctly, with "+" end up
and "–" end down.)
•Replace battery with new AA-size alkaline battery.
•Unscrew button cap assembly and reinstall, making
sure threads are aligned and engaged fully.
•Replace spark module assembly.
•Remove and reconnect all output connections at
module and electrodes.
•Remove and reconnect all output connections at
module and electrodes.
•If sparks are observed other than from burner(s),
wire insulation may be damaged. Replace wires.
•Replace battery with a new AA-size alkaline battery.
•Use paper towel to remove moisture.
•Replace cracked or broken electrodes.

Advertisement

Table of Contents
loading

Table of Contents