Advertisement
HOW TO SET THE ON TIMER
Press the
(ON TIMER) button, and the display changes as shown below.
Mode
Indication
4
1 hr
4
2 hrs
4
3 hrs
ON TIMER
Cancel ON TIMER
Q
Operation will start for setting temperature at setting time (The starting time may
different depend on the room temperature and set temperature).
HOW TO REPLACE THE BATTERIES IN THE REMOTE CONTROLLER
When using the remote controller, if there is no response from the air conditioner or the remote controller display is
dim, please try to replace the batteries.
4
10 hrs
4
11 hrs
4
12 hrs
1
1
Remove the cover as shown in the Ä gure and take out
the old batteries.
2
Install the new batteries.
The terminal of the batteries should match the marks in
the case.
CAUTION
1. Do not use new and old batteries, or different kinds of
batteries together.
2. Take out the batteries when you do not use the remote
controller for 2 months or longer.
3. Use high quality and high performance AAA batteries to avoid
short operating life and electrolyte leakages
– 4 –
NAMES AND FUNCTIONS OF REMOTE CONTROLLER
REMOTE CONTROLLER
This controls the operation of the air conditioner. Signal range to reach air conditioner is about 7 meters.
If inverter lamp is used, the range of control may be shorter.
It can be Ä xed on a wall using the Ä xture provided. Before Ä xing it, make sure the air conditioner can
be controlled from the remote controller.
MODEL: RA-08LEDF, RA-10LEDF and RA-13LEDF
<
>
IA1051: A
O
Transmission sign
The transmission sign blinks when a signal is sent.
O
Display
This indicates the room temperature setting, timer status, operation
mode and fan speed setting.
O
CIRCULATION button
Press this button to set air circulation in the room or start the
operation.
O
DEHUMIDIFYING button
Press this button to dehumidify the room or start the operation.
O
COOLING button
Press this button to set cooling mode in the room or start the
operation.
O
RESET button
O
STOP button
Press this button to stop the operation.
O
SLEEP TIMER button
Press this button to set the sleep timer.
O
FAN SPEED button
Press this button to change the fan speed. Every time you press
this button, the intensity of circulation will change from
to
(HI) to
(MED) to
(LOW).
O
AUTO SWING button
Press this button to set auto swing or stop angle of the vertical air
deÅ ector.
O
TEMPERATURE button
Press this button to raise or lower the temperature setting. (Keep
pressed, and the value will change more quickly.)
O
ON-TIMER button
Press this button to setting the turn on time.
Precautions
O
Do not put the remote controller in the following places.
O
In direct sunlight.
O
Near a heat source.
O
Handle the remote controller carefully. Do not drop it on the
Å oor, and away from water.
O
Once the air conditioner stops, it will not restart for about 3
minutes (unless you turn the power switch off and on or unplug
the power cord and plug it in again).
This is to protect the device and does not indicate a failure.
– 1 –
(AUTO)
Advertisement
