Engine Speed; Engine Zone Control - Husqvarna 67521HVE Owner's Manual

The operation of any lawn mower can result in foreign objects thrown into the eyes, which can result
in severe eye damage. Always wear safety glasses or eye shields while operating your lawn mower or
performing any adjustments or repairs. We recommend standard safety glasses or a wide vision safety
mask over spectacles.
HOW TO USE YOUR LAWN MOWER

ENGINE SPEED

The engine speed was set at the factory for optimum per-
formance. Speed is not adjustable.

ENGINE ZONE CONTROL

CAUTION: Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the risk
of blade contact injury. Do not un der
any cir cum stanc es attempt to defeat
the function of the operator control.
The blade turns when the engine is
running.
• Your lawn mower is equipped with an operator presence
control bar which requires the operator to be positioned
behind the lawn mower handle to start and operate the
lawn mower.
DRIVE CONTROL (See Fig. 6)
• Self-propelling is controlled by hold ing the operator
presence control bar down to the handle and pulling
the drive control lever rearward to the handle. The
farther toward the handle the lever is pulled, the faster
the unit will travel.
• Forward motion will stop when either the operator pres-
ence control bar or drive control lever are released. To
stop forward motion without stop ping engine, re lease
the drive control lever only. Hold op er a tor presence
control bar down against handle to con tin ue mowing
without self-propelling.
NOTE: If after releasing the drive control the mower will
not roll backwards, push the mower forward slightly to
disengage drive wheels.
OPERATOR PRESENCE CONTROL BAR
ADJUSTMENT TO ENGAGE
TURNBUCKLE DRIVE
(ON UNDERSIDE) CONTROL
DRIVE CONTROL ADJUSTMENT (See Fig. 6)
Over time, the drive control system may become "loose",
resulting in decreased speed. There is a turnbuckle on the
un der side of the drive control housing to increase tension
on the drive cable. Pro ceed as follows:
1. Turn unit off and disconnect spark plug wire from plug.
OPERATION
DRIVE
CONTROL
LEVER
DRIVE
CONTROL
DISENGAGED
FIG. 6
2. Turn nut on underside of drive control to increase drive
speed.
3. Operate mower to test drive speed. Readjust as required.
4. If condition fails to improve after the above steps (for-
ward speed remains the same), your drive belt is worn
and should be re placed.
TO ADJUST CUTTING HEIGHT (See Fig. 7)
Both front wheels are adjusted by a single lever on the left
front wheel. Likewise, both rear wheels are adjusted by a
single lever on the left rear wheel.
• Pull adjuster lever toward wheel. To raise mower, move
lever forward to desired position. To lower mow er, move
the lever toward the rear.
Be sure to adjust both front and rear wheels to same height.
LEVER BACKWARD
TO LOWER MOWER
TO CONVERT MOWER (See Figs. 8 thru 10)
Your lawn mower was shipped ready to be used as a mulcher.
To convert to rear bagging or side discharging:
REAR BAGGING
• Remove knob securing mulcher door to mower housing.
• Open mulcher door and insert tabs of discharge chute
into hinge bracket opening and position rear of chute
over threaded stud.
DISCHARGE CHUTE TABS
HINGE BRACKET
7
HEIGHT
ADJUSTER
LEVER
LEVER FORWARD
TO RAISE MOWER
FIG. 7
MULCHER DOOR
FIG. 8