Oregon Scientific JMR818WF User Manual page 3

A13 [ ON/OFF ] button
Activates and deactivates the alarm
A14 [ THERMO ] button
Alternates temperature display between indoor, outdoor,
and combined in / outdoor viewing display
A15 [ ALARM ] button
Displays the alarm-time or sets the alarm status
A16 Sensor
For indoor temperature reading
A17 [ RESET ] Button
Resets the unit by returning all settings to their default
values
A18 Battery Compartment
Accommodates four UM4 or AAA-size batteries
A19 Alarm
Sound vents for daily alarm
A20 Table Stand
For placing the unit on a flat surface
A21 Wall-Mount Hole
For mounting the unit on a wall
B REMOTE THERMO SENSOR
B1 LCD
Displays the current temperature monitored by the remote
unit
B2 LED indicator
Flashes when the remote unit transmits a reading
° °
B3 C/ F slide switch
Selects between Centigrade (°C) and Fahrenheit (°F)
B4 [ ] Battery-low indicator
Activates when the battery power is low
B5 Reset button
Returns all settings to default values
B6 Battery compartment
Accommodates two UM-4 or AAA size alkaline batteries
B7 Battery door
B8 Wall-mount holder
Supports the remote unit in wall-mounting
B9 Removable table-stand
For standing the remote unit on a flat surface
JMR818WF-E R1 R OP
Black
BATTERY INSTALLATION AND REMOTE
Follow this step-by-step procedure for installing batteries and
setting up the remote-sensor unit. Successful setup should ensure
that temperature signals are properly received.
Note: The effective range may be limited by building
materials and the position of either the main unit or the
remote thermo-sensor unit. Try various set-up arrangements
for best result.
Setting up the thermo-sensor unit:
The remote unit uses two (2) UM-4 or "AAA" size batteries.
Installation:
1. Remove the outer battery compartment door.
2. Remove inner screws and open the inner clearplastic
compartment door.
3. Select the temperature display unit on the
4. Insert the batteries strictly according to the polarities shown.
5. Replace the battery compartment door and secure its screws.
2
2
THERO-SENSOR SETUP
°
C/
8/27/04, 6:00 PM
°
F slide switch.