Smart Start TRANSMISSION REMOTE STARTER User Manual

Two -way fm led automatic/ manual transmission remote starter

Advertisement

T W O - W A Y F M L E D A U T O M A T I C / M A N U A L
T R A N S M I S S I O N
R E M O T E S T A R T E R
_____________
User Guide
It is the responsibility of the vehicle operator to ensure their
vehicle is parked in a safe and responsible manner.
a) Manual transmission: When leaving the vehicle, it is the user's
1.
responsibility to ensure that the gearshift lever is in the NEUTRAL
position and the parking brake is engaged in order to avoid accidents
upon remote starting.
b) Automatic transmission: When leaving the vehicle, it is the
user's responsibility to ensure that the gearshift lever is in "Park" in
order to avoid accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
It is the user's responsibility to ensure that the remote starter is
2.
disabled or put into valet mode before servicing.
Designed & engineered in Canada
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (EIRP) is not more than that required for successful communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user's authority to operate the equipment
Doc#: 120821
Rev:1.6
© 2012
WARNING
- 2W-FM-LED-A/M-HD -
- ME -
Canada

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TRANSMISSION REMOTE STARTER and is the answer not in the manual?

Questions and answers

Summary of Contents for Smart Start TRANSMISSION REMOTE STARTER

  • Page 1 T W O - W A Y F M L E D A U T O M A T I C / M A N U A L T R A N S M I S S I O N R E M O T E S T A R T E R _____________ User Guide...
  • Page 2: Table Of Contents

    Table of Contents Government regulations ......................3 Introduction with SmartStart™ ..................3 Using the Remote Control ...................... 4 Vehicle Presets ........................5 Heater ..........................5 Windshield Wipers & Radio & Headlights ................5 Arming and disarming the starter kill (if installed) .............. 6 Remote-Starting Your Vehicle ....................
  • Page 3: Government Regulations

    Diagnostics – Parking Light Flash Table Government regulations This device complies with part 15 of the FCC Rules. Operation is subject to the following two Parking lights flashes Description conditions: (1) This device may not cause harmful interference, and (2) this device must accept any Doors locked.
  • Page 4: Using The Remote Control

    Status Request When the Engine is Running Using the Remote Control When the vehicle doors are locked: The LED # 1 will flash 3 times to denote that the vehicle’s doors are locked. Your remote starter is equipped with a 5-button multi-channel remote control. It can operate two When the vehicle doors are unlocked: independent vehicles equipped with a remote starter (see Multi-car operation section on page- The LED # 2 will flash 3 times to denote that the vehicle’s doors are unlocked.
  • Page 5: Vehicle Presets

    1-way companion remote (where available) Vehicle Status Request LOCK: Locks the doors and arms the STARTER The status request feature allows the user to see the status of the vehicle i.e.: if the doors are KILL (if installed). locked or unlocked or if the vehicle is in cold weather mode, home valet mode, in valet mode or UNLOCK: Unlocks the doors and disarms the how much time is left in the run time cycle.
  • Page 6: Arming And Disarming The Starter Kill (If Installed)

    Multi-car Operation Arming and disarming the starter kill (if installed) This option allows the owner of two vehicles, both equipped with the same Remote Car Starter model, to control both systems with a single remote control. This added security feature will prevent the vehicle from starting with the Ignition key when the To control the second vehicle: starter kill is armed.
  • Page 7: Remote-Starting Your Vehicle

    “Home Valet ” Mode Remote-Starting Your Vehicle If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if the vehicle is parked indoors there is no danger of it starting accidentally by remote control. If the Setting Your Vehicle into Ready Mode vehicle has a manual transmission, it should be set into ready mode before activating the Home Valet™.
  • Page 8: Driving Off

    Driving Off Safe Start This feature will eliminate accidental remote starts, e.g. when children are playing with the With the vehicle running remotely, press the button to disarm the starter kill (if installed) and transmitter. unlock the doors. Enter the vehicle and do the following: Turn the ignition key to the IGNITION ON (RUN) position.
  • Page 9: Valet Mode

    Once the key is in the ON position, press on the brake pedal to put the Feature Confirmation Chart transmission in gear. Pressing the brake pedal at this step will cancel the remote starter takeover. Feature LOCK UNLOCK TRUNK START/STOP Beep(s) Drive off.
  • Page 10: Panic Mode

    To take the system out of Valet Mode To enter Cold Weather Mode (1-way remote): Using the KEY (Ignition Valet Mode): Rapidly press AUX twice. The remote’s LED will start flashing. Insert the ignition key into the ignition switch. Within 10 sec., cycle the ignition key to the Press and hold until the parking lights will flash for 2 seconds, pause, and then flash IGNITION/RUN and OFF positions 5 times until the parking lights flash twice.

Table of Contents