Smart Start AS-2780U User Manual

5-button automatic/manual transmission

Advertisement

Quick Links

5-BUTTON AUTOMATIC / MANUAL TRANSMISSION
REMOTE STARTER
AS-2780U
User Guide
It is the responsibility of the vehicle operator to ensure that their
vehicle is parked in a safe and responsible manner.
1. a) Manual transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in the NEUTRAL
position and the parking brake is engaged in order to avoid accidents
upon remote starting.
b) Automatic transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in "Park" in order to
avoid accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
2. It is the user's responsibility to ensure that the remote starter is
disabled or put into valet mode before servicing.
Designed & engineered in Canada
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation of
the device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (EIRP) is not more than that required for successful
communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the
equipment.
Doc#: 120821
Rev:1.9
© 2012
W W ARNING ! !
- AS-2780U -
- ME -
Canada

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AS-2780U and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Smart Start AS-2780U

  • Page 1 NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment. Doc#: 120821 Rev:1.9 © 2012 - AS-2780U - - ME - Canada...
  • Page 2: Table Of Contents

    Table of Contents Government regulations ........................3 Introduction ..........................3 Using the Remote Control ....................... 4 Vehicle Presets ..........................4 Heater ............................4 Windshield Wipers, Radio & Headlights ..................4 Arming and disarming the Starter Kill .................... 4 Remote-Starting Your Vehicle ......................5 Setting Your Vehicle into Ready Mode ..................
  • Page 3: Government Regulations

    Troubleshooting Poor Transmitting Range Government regulations Many factors may affect the operating range of the transmitter. Some of these are: This device complies with part 15 of the FCC Rules. Operation is subject to the following two The condition of the battery in the transmitter. conditions: (1) This device may not cause harmful interference, and (2) this device must accept any The operating environment (for example: downtown radio-frequency noise, airports, cellular interference received, including interference that may cause undesired operation.
  • Page 4: Using The Remote Control

    To disarm the OEM-style alarm, press the button on the transmitter. Using the Remote Control -To stop the horn from sounding if the OEM-style alarm is triggered, press the button, or put the system in and out of Valet Mode (page-8) Your Remote Car Starter is equipped with a 5-button multi-channel remote control.
  • Page 5: Remote-Starting Your Vehicle

    Note: If the Starter Kill is installed, the vehicle will benefit from a protection against starter Press the button. motor damage that could occur after remote-starting the engine should the user, by force of Within 3 seconds, press the buttons simultaneously for 3 sec. habit, turn the ignition key to the CRANK position.
  • Page 6: Remote-Starting

    To set the system to Ready Mode: Safe Start If Ready Mode is enabled by remote If Ready Mode is enabled by handbrake Safe start enabled: If this feature is enabled, the user must press the button 1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the neutral twice within 3 seconds to remote-start the vehicle.
  • Page 7: Remote Starter Features

    Example: If your Module is programmed for a runtime of 3 minutes and your vehicle has been Remote Starter Features running for 2 minutes already, pressing the button will reset the counter to zero and the Engine will run for another cycle (in this case, 3 minutes). Remote Door Locks Disable/Enable LED flashing If your system was installed with the Remote Door Locks option, you will have the convenience of...
  • Page 8: Valet Mode

    Open and close all doors. Panic Mode You have 1.5 minutes (or 3 minutes) to press on the brake pedal, to get in gear and Note: Panic mode can only be activated if the horn has been adequately configured by the drive off.

Table of Contents