Turn On & Turn Off; Spindle Lock - DeWalt D28810 Instruction Manual

WARNING: 100mm abrasive wheels with rated max. speed lower
than 13500RPM can't be used on this grinder. Accessories must be
rated for at least the speed recommended on the tool warning label.
Wheels and other accessories running over rated accessory speed
may burst and cause injury. Threaded accessories must have a
M10 hub. Every unthreaded accessory must have a 16mm arbor
hole. If it does not, it may have been designed for a circular saw and
should not be used. Use only the accessories shown on pages
9–10 of this manual. Accessory ratings must be above listed
minimum wheel speed as shown on tool nameplate.
Switches
CAUTION: Hold the side handle and body of the tool firmly to
maintain control of the tool at start up and during use and until the
wheel or accessory stops rotating. Make sure the wheel has come
to a complete stop before laying the tool down.
NOTE: To reduce unexpected tool movement, do not switch the
tool on or off while under load conditions. Allow the grinder to run
up to full speed before touching the work surface. Lift the tool from
the surface before turning the tool off. Allow the tool to stop rotating
before putting it down.
TURN ON & TURN OFF
To turn on the tool, push the toggle switch(N) to ''1"
position, to turn off the tool, push the toggle
switch(N) to "0" position.

SPINDLE LOCK

The spindle lock (A) is provided to prevent the spindle from rotat-
ing when installing or removing wheels. Operate the spindle lock
only when the tool is turned off, unplugged
from the power supply, and has come to a
complete stop. Do not engage the spindle
lock while the tool is operating because
damage to the tool will result. To engage the
lock, depress the spindle lock button and
rotate the spindle until you are unable to
rotate the spindle further.
N
A A
9
100mm Grinding Wheels
Type 27 guard
backing flange
Type 27 hubbed wheel
Type 27 depressed
center wheel
threaded clamp nut
Wire Wheels
Type 27 guard
75mm/100mm
wire cupbrush
Type 27 guard
Type 27 guard
75mm/100mm
wire wheel