JVC HX-Z30 Service Manual page 4

3.1.2 Removing the CD changer mechanism assembly
(See Fig.4, 5)
• Prior to performing the following procedure, remove the metal
cover.
(1) Disconnect the card wire from connector
servo control board on the right bottom of the CD changer
mechanism assembly.
(2) Remove the four screws C attaching the CD changer
mechanism assembly on top of the body.
(3) Remove the CD changer mechanism assembly while lifting
the rear part.
CAUTION:
Do not damage the CD fitting when removing the CD changer
mechanism assembly.
CN651 on the CD
Front panel assemby
C
CD changer mechanism assembly
CD servo control board
CN651
Fig.4
CD changer
mechanism assembly
Fig.5
(No.MB043)1-7
C