Jenn-Air FREESTANDING OUTDOOR GRILLS Installation Instructions And Use & Care Manual page 16

4. Use 6 mm socket wrench or 6 mm nut driver to remove the
orifice. Replace with the Natural gas orifice.
IMPORTANT: Check that the orifice is properly installed
inside of the valve.
5. Reinstall the side burner. Make sure that the igniter is out of
the way to allow proper positioning of burner. Use Phillips
screwdriver to attach the mounting screws.
6. Use Phillips screwdriver to reattach the igniter and side
burner plate.
7. Reinstall side burner cover. Use Phillips screwdriver to attach
mounting screws.
Change the Oven Burner Orifice
1. Use a Phillips screwdriver to remove the access panel from
the rear of the oven.
16
A
A. Orifice
2. Grasp brass elbow with vice grip or pliers and remove from
end of gas supply valve.
A. Brass elbow
3. Use 10 mm socket wrench 10 mm nut driver to remove the
LP orifice at the end of the supply pipe. Replace with the
Natural gas orifice.
A
IMPORTANT: Check that the orifice is properly installed
inside of the supply pipe.
4. Reinstall the access panel
5. Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A
A. Closed valve
B. Open valve
6. Test all connections using an approved noncorrosive leak-
detection solution. Bubbles will show a leak. Correct any leak
found.
A
A. Orifice
B