Skoda Octavia Owner's Manual page 16

The display appears in litres/hour if the vehicle is stationary or driving at a low
speed .
1)
Average fuel consumption
The average fuel consumption since the memory was last erased is shown in the
display in litres/100 km » page 12.
2)
If you wish to determine the average fuel consumption over a certain period of
time, you must set the memory at the start of the new measurement to zero us-
ing the button » Fig. 6 on page 13. After erasing the memory, no value appears
B
in the display until you have driven 300 m.
The display is updated regularly while you are driving.
Range
The estimated range in kilometres is shown on the display. It indicates the dis-
tance you can still drive with your vehicle based on the level of fuel in the tank
and the same style of driving.
The display is shown in steps of 10 km. After lighting up of the warning light for
the fuel reserve the display is shown in steps of 5 km.
The fuel consumption over the last 50 km is used to calculate the range. The
range will increase if you drive in a more economical manner.
If the memory is set to zero (after disconnecting the battery), the fuel consump-
tion of 10 ltr./100 km is calculated for the range; afterwards the value is adapted
accordingly to the style of driving.
Distance travelled
The distance driven since the memory was last erased appears in the dis-
play » page 12.
If you wish to measure the distance travelled from a particular point in time, you
need to set the memory to zero at this point in time by pressing the button
» Fig. 6 on page 13 or .
B D
The maximum distance indicated in both memories is 1 999 km or 9 999 km on
vehicles with an information display. The indicator is set back to zero if this period
is exceeded.
1)
On some models in certain countries, the display appears in --,- kilometres/litres if the vehicle is sta-
tionary.
2)
On some models in certain countries, the display appears in kilometres/litre.
14
Using the system
Average speed
The average speed since the memory was last erased is shown in the display in
km/hour » page 12. If you wish to determine the average speed over a certain pe-
riod of time, you need to set the memory to zero at the start of the measurement
using the button » Fig. 6 on page 13 or
B
After erasing the memory, no value appears in the display until you have driven
approx. 300 m.
The display is updated regularly while you are driving.
Current speed
The current speed which is identical to the display of the speedometer
on page 8 is indicated on the display.
Oil temperature
If the oil temperature is lower than 50 °C or if a fault in the system for checking
the oil temperature is present, - -.- is displayed instead of the oil temperature.
Warning against excessive speeds
ä
First read and observe the introductory information and safety warn-
ings on page 12.
Adjust the speed limit while the vehicle is stationary
›
With the button » Fig. 6 on page 13 or, if applicable, the adjustment wheel
A
, select the menu item Warning against excessive speeds.
D
›
Press the button or to activate the ability to set the speed limit (value
B D
flashes).
›
Set the desired speed limit, e.g. 50 km/h, with the button
the adjustment wheel .
D
›
Press the button or to confirm the set speed limit, or wait approx. 5 sec-
B D
onds and the setting is saved automatically (the value stops flashing).
This allows you to set the speed in 5 km/h intervals.
Adjusting the speed limit while the vehicle is moving
›
With the button » Fig. 6 on page 13 or, if applicable, the adjustment wheel
A
, select the menu item Warning against excessive speeds.
D
›
Drive at the desired speed, e.g. 50 km/h.
.
D
» Fig. 2
2
or, if applicable,
A
Ð
£