Service Or Repair - Linear Power 1002 Owner's Manual And Installation Manual

insulation exposing the ground braid. Cut the braid and fold back Strip 2-3 of
insulation off a scrap piece of wire and wrap around the ground braid next to the
plug closest to the amp and wrap the entire connection with electrical tape. Try
grounding this signal ground at several different locations in the vehicle while
carefully listening to the amount of engine noise at each location. Attach this
signal ground wire to the location, which causes the least amount of engine
noise. Only one input plug needs the signal ground wire attached, the other input
need only have its ground braid broken.

SERVICE OR REPAIR

To obtain modification, service or repair, please contact our ONLY Authorized
LINEAR POWER™ Product Service Center:
T.I.P.S. INC.
3455 Lanell lane, Pearl, MS 39208
(601) 932-8477
E-mail: ray@tipsinc.net
™
3 4 5 5 L A N EL L L A N E, P E A R L, M S 3 9 2 0 8 (6 0 1) 9 3 2 – 8 4 7 7
© 2008 Linear Power, Inc. - ALL RIGHTS RESERVED
7
LINEAR POWER™ is a trademark of Linear Power, Inc.