Fiberstars 6004 Owner's Manual page 3

HOW IT WORKS
Before switching on the 6004-AS illuminators, make sure color wheel switch is in "OFF"
position. Turn on the power to the illuminators, the color wheels will rotate to the "HOME"
position. This action takes about 15 seconds. At this time, all AS units should be holding on
the same color.
After the color wheels have reached their home positions, the color wheels can be switched
on. The units should now be in sync. When shutting down the system, always turn the color
wheel OFF so the next time the lights are turned on, the color wheels can return to their
home position again, assuring syncronization.
Lamp "Restrike"
When turning the system off and then turning it immediately
back on, it may take 1 to 3 minutes before the lamp comes
back on.
This process allows the lamp to cool down and then restart.
This is a normal function of the Metal-Halide lamp system that
the Fiberstars 6004 / 6004-AS illuminator uses.
6000 Series Warranty
Should any 6004 / 6004-AS component fail during the initial three (3) years
of recommended use from the date of installation, Fiberstars will replace the
failed component(s) without charge. At anytime after the initial three (3) year
period, Fiberstars will replace the failed component(s) for a nominal charge.
The nominal charge will be based on 50% (fifty percent) of the manufacturer' s
suggested retail price of the component at the time of replacement. The failed
component(s) must be returned to Fiberstars, or any Fiberstars Authorized
Service Center.
The RM6000 remote control has a seperate warranty and does not
fall under this 6004/6004-AS illuminator warranty coverage.
This warranty applies only to the original owner for as long as they own the
6004 / 6004-AS illuminator. This warranty is non-transferrable.