1. Position remote control into neutral.
2. Install the throttle cable to the throttle arm with a flat washer
and locknut. Tighten the locknut, then back off the locknut 1/4
turn.
3. Adjust the cable barrel so that the installed throttle cable will
hold the throttle arm against the idle stop.
4. Place the cable barrel into the barrel retainer.
5. Lock the retainer and cables in place with the cable latch.
c
d
e
a -
Flat washer
b -
Locknut
c -
Barrel retainer
OUTBOARD INSTALLATION
N
26838
d -
Cable barrel
e -
Cable latch
110
a
b
15317