White Outdoor LT-5 Service Manual page 33

16.4. A spacer is fits between the dash and the side
panel, around the lower rear bolt that fastens the
side panel to the dash. See Figure 16.4.
Spacer
Figure 16.4
NOTE: A 3/8" wrench fits the lower rear bolt, but
there is a nut inside the dash panel that must be
held with a 7/16" wrench.
16.5. Remove the front screws securing the grille with
two 1/2" wrenches. See Figure 16.5.
1/2" Wrenches
Figure 16.5
16.6. Lift the grill, side panels, and hood off of the front
on the lawn tractor.
16.7. Raise and secure the front of the frame to allow
removal of the front wheels.
NOTE: Do not use the pivot bar as a means to
suspend the front of the lawn tractor.
16.8. Remove the front wheels.
3/8"
bolt head
29
700 SERIES LAWN TRACTORS
16.9. Remove the cotter pins that secure the tie rod to
the axle.
NOTE: Discard the cotter pins and replace with
new hardware.
16.10. Remove the muffler heat shield and the muffler
as one unit. See Figure 16.10.
Exhaust pipe
Figure 16.10
16.11. Disassemble axles from the pivot bar.
16.12. Remove the shoulder bolts that pass through the
front hanger bracket, front pivot bracket, pivot
bar, and frame.
Front hanger
bracket
Figure 16.12
Muffler and
heat shield
See Figure 16.12.
Shoulder
bolt