Related Manuals for Stagg SPA-SUB 1208 EUR
Summary of Contents for Stagg SPA-SUB 1208 EUR
-
Page 1: User Guide
USER GUIDE MULTI PURPOSE AMPLIFIED SPEAKER CABINETS SPA-SUB 1208 EUR SPA-SUB 1510 EUR SPA-SUB 1512 EUR SPA-SUB 1810 EUR... -
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS READ AND KEEP THESE INSTRUCTIONS. HEED ALL WARNINGS. • This active speaker system must be connected to a mains (AC) outlet to work properly and must be earthed to operate safely. • Ensure that correct AC mains voltage and socket - fitted with a real ground connection – are available before powering up the unit. -
Page 3: Mechanical Features
The cabinet of the SUB WOOFER hosts the woofer and its power amp, the electronic crossover and two amps that drive the two separate mid-high speakers. The Stagg SPA-SUB 1208 consists of a sub cabinet with a 12” woofer and two satellites with a 8” mid speaker and a compression horn tweeter. -
Page 4: Technical Specifications
TECHNICAL SPECIFICATIONS Specifi cation SPA-SUB1208 SPA-SUB1510 Subwoofer Subwoofer 12”*1, aluminum 15”*1, aluminum Woofer speaker frame,75mm voice frame,100mm voice coil, 100oz coil,125oz Frequency Range 40Hz-130Hz 40Hz-130Hz Impedance 8 Ohm 8 Ohm Sensitivity (1m/1W) 92dB 95dB Max SPL 107dB 117dB Output Power 1*300W 1*500W Speaker... -
Page 5: Operating Instructions
OPERATING INSTRUCTIONS THE Stagg SPA-SUB sets are active sets, which means they have all necessary power amps on board. The only thing you need to do to make them work is connect audio signals to the inputs on the control panel of the sub, connect the 2 satellite speakers with speaker cables to the sub, connect the mains cable, switch on the unit and adjust the volumes of sub speaker and satellites. -
Page 7: Mains Section
CONTROLS 5. SUB WOOFER LEVEL: This control determines the volume of the low frequencies . 6. CLIP LED: This 3 colour LED shines green as long as the limiting device is not “limiting” the low signal. The LED shines orange when the signal starts to be limited to avoid distortion. This happens when the signal to the output power stage becomes too loud. - Page 8 DISTRIBUTOR / DEALER...