Bar And Chain Combinations; Saw Chain Filing And File Gauges - Husqvarna 1153163-95 Operator's Manual

Recommended original and replacement bar and chain combinations
Following is a list of recommended cutting equipment for the Husqvarna chain saw models 346XP and 353. The
combinations of power head, bar and chain have been tested and found to be in accordance with the kickback and
vibration requirements of ANSI B175.1–2000.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a hard nose.
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy. A hard nose bar having the same length and nose
radius as a sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-nose bar.
Recommended cutting equipment for Canada

Bar and chain combinations

The following cutting attachments are approved for the models Husqvarna 346XP, 346XPG, 346XP E-tech, 346XPG E-
tech, 353, 353G, 353 E-tech and 353G E-tech.
Chain saw models Husqvarna 346XP and 353 met the kickback performance requirements of ANSI B 175.1-2000 when
tested with the combinations of bars and saw chains listed below. The saw chain Husqvarna H30 is also classified as a
low kickback saw chain since it met the requirements for low kickback saw chain outlined in ANSI B 175.1-2000. We
recommend to use only the listed combinations of bars and chains for chain saw models Husqvarna 346XP and 353.
Other chain saw models may not meet the kickback requirements when equipped with the listed bar and chain
combinations.
Length, inch Pitch, inch
13 0,325
15 0,325
16 0,325
18 0,325
20 0,325
13 0,325
15 0,325
16 0,325
18 0,325
20 0,325
Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the
corresponding bar, see the table below.
0,050" H30 H22
0,058" - H25
Saw chain filing and file gauges
40 – English
TECHNICAL DATA
Bar
Gauge, inch Max. nose radius
1,3 10T
1,3 10T
1,3 10T
1,3 10T
1,3 10T
1,5 10T
1,5 10T
1,5 10T
1,5 10T
1,5 12T
Chain
Type Drive link count
56
64
Husqvarna H30 66
72
78
56
64
Husqvarna H25 66
72
78