Connecting The Wso100; Figure 2 - Wso100 Interface Connector; Figure 3 - Nmea 2000 Connector Face Views - Maretron WSO100 User Manual

WSO100 User's Manual

2.4 Connecting the WSO100

®
The Maretron WSO100 provides a connection to an NMEA 2000 interface through a
connector that can be found on the bottom of the device (see Figure 2).
Figure 2 – WSO100 Interface Connector
®
The NMEA 2000 connector is a five pin male connector (see Figure 3). You connect the
® ®
WSO100 to an NMEA 2000 network using a Maretron NMEA 2000 cable (or compatible
cable) by connecting the female end of the cable to the WSO100 (note the key on the male
connector and keyway on the female connector). Be sure the cable is connected securely and
that the collar on the cable connector is tightened firmly. Connect the other end of the cable
®
(male) to the NMEA 2000 network in the same manner. The WSO100 is designed such that
®
you can plug or unplug it from an NMEA 2000 network while the power to the network is
®
connected or disconnected. Please follow recommended practices for installing NMEA 2000
network products.
®
Figure 3 – NMEA 2000 Connector Face Views
Page 4 Revision 1.2