Bar And Chain Combinations; Saw Chain Filing And File Gauges - Husqvarna 1151438-95 Operator's Manual

Recommended original and replacement bar and chain combinations
Following is a list of recommended cutting equipment for the Husqvarna chain saw models 345e TrioBrake, 346XP TrioBrake
and 353 TrioBrake. The combinations of power head, bar and chain have been investigated in accordance with the kickback
and vibration requirements of ANSI B 175.1–2000.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a solid bar.
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which will
also achieve kickback reduction.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For
guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth
may be considered to have equivalent kickback energy. A hard nose bar having the same length and nose radius as a
sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-nose bar.

Bar and chain combinations

Low kickback saw chain is a chain which has only met the kickback performance requirements of ANSI B 175.1 safety
requirements for gasoline powered chain saws when tested on the representative sample of chain saws below 3.8 cu. in.
specified in ANSI 175.1. We recommend that you as a replacement use the listed chains or "Low kickback saw chains" which
are available at your dealer.
Length, inch Pitch, inch
13 0,325
15 0,325
16 0,325
18 0,325
20 0,325
13 0,325
15 0,325
16 0,325
18 0,325
20 0,325
Note: For the chains above you are free to choose between 0,050" and 0,058" gauge drive link for the corresponding bar, see
the table below.
0,050"/1,3 mm
0,058"/1,5 mm
Saw chain filing and file gauges
TECHNICAL DATA
Bar
Gauge, inch
1,3
1,5
H30 H22
- H25
Max. nose radius Type
10T
10T
10T Husqvarna H30
10T
10T
10T
10T
10T Husqvarna H25
10T
12T
Chain
Drive link count
56
64
66
72
78
56
64
66
72
78
English – 41