Starting And Stopping - Husqvarna 115 13 82-49 Operator's Manual

Epa iii
Table of Contents

Advertisement

Available languages

Available languages

by disengaging the throttle lock. Disengagement is done
by gently touching on the throttle trigger. This prevents
unnecessary wear to the clutch, clutch drum and brake
band.
Allow the machine to idle a few seconds before giving full
throttle.
CAUTION! Do not pull the starter cord all the way out and
do not let go of the starter handle when the cord is fully
extended. This can damage the machine.
Note! Pull the front hand guard towards the front handle.
The chain brake is now disengaged. Your saw is ready for
use.
WARNING! Long term inhalation of the
!
engine's exhaust fumes, chain oil mist
and dust from sawdust can represent a
health risk.
Never start a chain saw unless the bar, chain and all
covers are fitted correctly. See instructions under the
heading Assembly. Without a bar and chain attached
to the chain saw the clutch can come loose and cause
serious injury.
The chain brake should be activated when starting. Se
instructions under the heading Start and stop. Do not
115 13 82-49 Rev.1 2009-08-21

STARTING AND STOPPING

drop start. This method is very dangerous because
you may lose control of the saw.
Never start the machine indoors. Exhaust fumes can
be dangerous if inhaled.
Observe your surroundings and make sure that there
is no risk of people or animals coming into contact with
the cutting equipment.
Always hold the saw with both hands. The right hand
should be on the rear handle, and the left hand on the
front handle. All people, whether right or left handed,
should use this grip. Use a firm grip with thumbs and
fingers encircling the chain saw handles.
Stopping
Stop the engine by switching off the ignition.
English
23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

455e rancher455 rancher460 rancher

Table of Contents