Table of Contents
Advertisement
Installation
Instructions
Questions? Call 1-800-561-3344
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
Note to Installer –
•
instructions with the consumer.
Note to Consumer –
•
for future reference.
Skill level
•
– Installation of this vent hood requires
basic mechanical and electrical skills.
Completion time
•
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the warranty.
WARNING –
TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
A. Installation work and electrical wiring must be
done by qualified person(s) in accordance
with all applicable codes and standards,
including fire-rated construction.
B. Sufficient air is needed for proper
combustion and exhausting of gases through
the flue (chimney) of fuel burning equipment
to prevent back drafting. Follow the heating
equipment manufacturer's guideline and
safety standards such as those published by
the National Fire Protection Association
(NFPA), and the American Society for
Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code
authorities.
C. When cutting or drilling into wall or ceiling,
do not damage electrical wiring and other
hidden utilities.
D. Ducted fans must always be vented to the
outdoors.
or Visit our Website at: www.
Save these
Observe all
Be sure to leave these
Keep these instructions
– 1 to 3 hours.
Range Hood
GEAppliances.ca
PRODUCT DIMENSIONS
Knockouts
(Junction Box)
Top
Screw
Location
HOOD WIDTH
30"
36"
1 Ft = 0.3 m
1" = 2.5 cm
WARNING –
USE ONLY METAL DUCTWORK.
Do not attempt to repair or replace any
part of your hood unless it is specifically
recommended in this guide. All other servicing
should be referred to a qualified technician.
CAUTION –
TO PROPERLY EXHAUST AIR.
Be sure to duct air outside - Do not vent exhaust air
into spaces within walls or ceilings or into attics,
crawl spaces, or garages."
FOR YOUR SAFETY:
WARNING –
installation, switch power off at service panel and lock
the service disconnecting means to prevent power
from being switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag,
to the service panel.
7
Side Slot x 4
Top Outlet
Rear
Outlet
Bottom Fixing
Screws Locations
DIM. "W" DIM. "K" DIM. "Z"
29-1/8"
2-1/2"
35-1/16"
2-1/2"
TO REDUCE THE RISK OF FIRE,
TO REDUCE THE RISK OF FIRE AND
Before beginning the
Top Screw
Location
Square Slot
7-1/16"
7-1/16"
Advertisement
Table of Contents
