Ninja Kitchen System 1200 Owner's Manual page 9

Fig. 1
Fig. 2
HOW TO ASSEMBLE
CAUTION: Make sure that the motor base
is unplugged from the power source.
1 Place the motor base on a clean, dry,
level surface such as a counter or table
top. (Fig. 1)
2 Lower the pitcher or the bowl onto the
motor base. (Fig. 1)
3 Rotate the container to the left as far as
it will go. As the container rotates, it will
lower and the safety tabs on the bottom
of the container will slide under the
safety tabs on the top of the motor base.
(Fig. 2)
4 The pitcher or bowl can be placed on the
motor base two ways; the handle can be
on the front right corner or the front left
corner. (Fig. 3a, Fig. 3b)
5 Holding the desired attachment by the
shaft, place it onto the gear shaft inside
the container. Ensure that the attachment
fits around the gear shaft and that it is
standing straight. (Fig. 4a, Fig. 4b)
BL700_30_SERIES_IB_ENG_120427_2.indd 9
Shaft
Fig. 3a
Fig. 4a
Fig. 3b
HOW TO USE
1
Place the pitcher or bowl onto the motor
base and insert the desired attachment.
(See HOW TO ASSEMBLE.)
2 Add the ingredients to the container.
Make sure your total of ingredients don't
exceed the highest measured marking
line on the side of the containers.
MAXIMUM CAPACITY
40-oz Bowl
Dry - Do not exceed 2 1/2 cups (20 oz.)
Wet - Do not exceed 5 cups (40 oz.)
72-oz Pitcher
Dry - Do not exceed 2 1/2 cups (20 oz.)
Wet - Do not exceed 9 cups (72 oz.)
Shaft
Fig. 4b
www.ninjakitchen.com
9
12-04-30 8:41 AM