Troubleshooting Guide; Replacement Parts - Ninja Kitchen System 1200 Owner's Manual

Troubleshooting Guide

PROBLEMS
Motor Doesn't Start or
Attachment Doesn't
Rotate.
Food is Unevenly
Chopped.
Food is Chopped Too
Fine or is Too Watery.
You Cannot Achieve
Snow From Solid Ice.
Motor Base Won't
Stick to Counter or
Table Top.

Replacement Parts

ORDERING REPLACEMENT PARTS
To order additional parts and attachments, please visit our website:
www.ninjakitchen.com or feel free to contact customer service: 1-877-646-5288.
16
BL700_30_SERIES_IB_ENG_120427_2.indd 16
Make sure the container is securely placed on motor
base.
Make sure the lid is securely on container in the correct
position (align arrows).
The appliance is turned Off. Press the power button (
turn On.
Check that the plug is securely inserted into the electrical
outlet.
Check the fuse or circuit breaker.
The unit has overloaded. The appliance will stop and the
power light will remain on while speeds 1, 2 and 3 will flash.
Unplug and wait approximately 15 minutes before using
again.
The unit has overheated. Unplug the unit and wait 15 minutes
to reset.
Make sure that the power button
that the appliance is assembled correctly.
Check to make sure the unit is not overloaded.
Either you are chopping too much food at one time, or
the pieces are not of even size and processing smaller
amounts per batch.
The food has been over processed. Use pulse button for
controlled processing.
Do not use ice that has been sitting out or has started to
melt. Use ice straight from the freezer.
Make sure the surface is wiped clean. The suction feet will
only stick to smooth surfaces.
DO NOT attempt to use appliance when the motor base is
stuck to a surface that is not secure, (cutting board, platter,
plates, etc.).
TOLL FREE: 1-877-646-5288
POSSIBLE REASONS & SOLUTIONS
)
to
) is a solid red and
(
12-04-30 8:41 AM