Improper earth connection may cause electric shock. Use only optional parts authorized by Mitsubishi Electric. If the accessories are installed improperly, water leakage, electric shock Please pay attention to the refrigerant (Freon gas).
1.2 During operation. Do not touch the compressor or refrigerant piping without wearing glove on your hands. Warning. Touching directly such the parts can cause a burn or frostbite as it becomes high or low temperature Refrain from exposing yourself to cooled air for a long according to the refrigerant state.
2. Caution before using. 4.1 Cleaning of panel. Clean dirt of panel as follows. For safety, confirm that the earth terminal has been Use a household neutral cleanser such as for dishes or vegetables. connected to the earth wire correctly. Moisten a soft cloth with the cleanser, then wipe lightly.
5. Transferring work, and construction. 5.5 Disposing of the unit. When you need to dispose of the unit, consult your dealer. 5.1 Transfer of installation. If pipes are removed incorrectly, refrigerant (fluorocarbon gas) may blow out and come into contact with your skin, causing injury. 1.
6. How to operate : In case of using LCD remote controller. If you use the LCD remote controller, you can operate below method. Please consult operate method with dealer, if you use field supply control parts. Display section 6.1 ON / OFF Operation lamp Start operation Press the [ON/OFF] button...
6.2 Selecting operation 6.3 Room temperature adjustment Operation mode display Set temperature display and room temperature display When selecting operation To change room temperature Press the [MODE] button Press the [SET TEMP] button and set the room temperature Consecutive press of the [MODE] button switches the operation over of your choice.
6.4 Time setting 6.5 Other function Current time display Timer Hold/Resume display Key lock Press the [MINUTE] button three times consecutively, the word "KEY LOCK" will displayed Clock setting At this time, only [ON-OFF] button is valid. Press the [CLOCK] key one time will activate set clock mode.
7. Troubleshooting Before you ask for repair service, check the following points: LCD remote Controller State of Machine Cause Press the [ON/OFF] button after power restoration. Power failure Troubleshooting It does not run. "ON-OFF "display is not lit up The power supply is turned OFF. Turn the power supply ON.
Page 11
Please be sure to put the contact address/telephone number on the operation manual before handing it to the customer. HEAD OFFICE MITSUBISHI DENKI BLDG MARUNOUCHI TOKYO 100-0005 TELEX J24532 CABLE MELCO TOKYO WT03427X03 Specifications subject to change without notice.