Troubleshooting - Ryobi RLT36 Operator's Manual

Problem
String will not advance when using the
auto-feed head.
Grass wraps around shaft housing and
cutting head.
Motor fails to start when switch trigger is
depressed.
English (Original Instructions)

TROUBLESHOOTING

Possible cause
String is welded to itself.
Not enough string on spool.
String is worn too short.
String is tangled on spool.
Cutting tall grass at ground level.
Battery is not secure.
Battery is not charged.
Shaft not connected completely.
9
Solution
Lubricate with silicone spray.
Install more string. Refer to string
replacement earlier in this manual.
Pull string while pressing line release
button.
Remove string from spool and rewind.
Refer to string replacement earlier in this
manual.
Cut tall grass from the top down to
prevent wrapping.
To secure the battery pack, make sure
the latch on bottom of the battery pack
snaps into place.
Charge the battery pack according to the
instructions included with your model.
Make sure the lower curve shaft is fully
seated and secured in the shaft coupling
on the upper shaft.