Husqvarna 343R, 345RX, 343F, 345FX, 345FXT Workshop Manual page 29

3
28
Fuel system
G
Remove the bolt (A) and remove the
throttle from the handle.
Remove bolts (B) and (C).
Separate the halves of the throttle.
Check for wear on pins (A) and (B).
Replace the throttle control (C) and
lever arm (D) if necessary.
Check that the cables are properly
pressed into the cut-outs (E) and that
the throttle cable (F) is in the right
groove.
If necessary, attach it with silicon
adhesive in order to facilitate assembly.
Check that the protective bellows (G)
are whole and that they are correctly
mounted over the ball on the cable.
Remove the bolt (A) that attaches the
throttle to the handle.
Be careful not to lose the nut.
Remove the throttle and remove bolts
(B) and (C).
Carefully separate the two halves of the
throttle.