All-Wheel Drive Warning Light (Awd At Vehicles); Selector Lever Position Indicator (At Vehicles); Turn Signal Indicator Lights; High Beam Indicator Light - Saab 92X Owner's Manual

3-14
Instruments and controls
Always make sure this light is out before
you start to drive.
¢ All-Wheel Drive warn-
ing light (AWD AT vehi-
cles)
Continuing to drive with the AWD
warning light flashing can damage
the powertrain. If the AWD warning
light starts to flash, promptly park in
a safe place and check whether the
tires have differing diameters and
whether any of the tires has an ex-
cessively low inflation pressure.
The All-Wheel Drive warning light comes
on when the ignition switch is turned to the
"ON" position and goes out after the en-
gine has started.
This light comes on when All-Wheel Drive
is disengaged and the drive mechanism is
switched to Front Wheel Drive for mainte-
nance or similar purposes (Non-turbo ve-
hicles).
It flashes if the vehicle is driven with tires
of differing diameters fitted on the wheels
or with an excessively low air pressure in
any of the tires.
¢ Selector lever position indi-
cator (AT vehicles)
P
R
N
D
3
2
1
This indicator shows the position of the
selector lever.
¢ Turn signal indicator
lights
These lights show the operation of the
turn signal or lane change signal.
If the indicator lights do not blink or blink
rapidly, the turn signal bulb may be
burned out. Replace the bulb as soon as
possible. Refer to the "Replacing bulbs"
section in chapter 11.
¢ High beam indicator
light
This light shows that the headlights are in
the high beam mode.
This indicator light also comes on when
the headlight flasher is operated.
¢ Cruise control indica-
tor light
The cruise control indicator light comes on
when the ignition switch is turned to the
"ON" position and goes out after approxi-
mately three seconds.
300630 This light comes on when the "CRUISE"
main switch is pressed.
If it flashes during driving, deactivate the
cruise control system and contact your
Saab dealer for an inspection. Refer to
"Cruise control" in chapter 7 for the deac-
tivation procedure of the cruise control
system.
NOTE
If you move the cruise control lever or
press the main switch button while
turning the ignition switch "ON", the
cruise control function is deactivated
and the "CRUISE" indicator light flash-
es. To reactivate the cruise control
function, turn the ignition switch back