Table of Contents
Advertisement
Installation
Installation
1) Separate the dome cover by counterclockwise rotation.
Latch
[Figure-1]
* To install the dome cover on the camera
body, turn the latches in locking direction
as shown in the figure 1.
Notes
• T he installation should be done by qualified
service personnel or system installers.
• I f the ceiling material is not strong enough to
hold the installation screws, the camera may
fall off. Reinforce the ceiling as needed.
• T o change the position of the cable, take
away the Hole Cover and pass the cable
through.
10
COLOR DOME CAMERA
Main Body
(Camera)
Locking Direction
(Clockwise)
Dome Cover
Original position of
the cable
Hole Cover
User's Manual
When using the Ceiling bracket
1) Hold the ceiling bracket (located where the arrow
An arrow for installing
Ceiling bracket
directions
2) Adjust the camera lens to face the area to be
M4 tapping
screw (provided)
Locking direction
Unlocking
direction
Dome Cover
Notes
• I f you want to install the camera with the ceiling bracket combined, fix it using two M4
tapping screws at the side of the main body(refer to the [Figure-2] on page 11)
COLOR DOME CAMERA
Installation
points to) and separate it from the main body of
the camera by rotating it counterclockwise.
(refer to the picture in 'Notes' on page 10)
monitored and fix the main body and the dome
cover by aligning the grooves and rotating the
body clockwise.
Pan Base
fixation
screw
M4
tapping
screw
[Figure-2]
11
User's Manual
Advertisement
Table of Contents
