The ASCENDO Loudspeaker C8-C intended for use in small to mid-size rooms size rooms (< 100 m³ You can use the C8-C with amplifiers in the power range of 10 W to 350 W. with amplifiers in the power range of 10 W to 350 W. Safety Warning...
Operating modes You can use the C8-C a single-amp setup (one power amplifier for high- and low-frequency unit) or in a bi-amp setup (one power amplifier for the low-frequency-unit, one for the high- frequency unit). If your setup is single-amp you must bridge the high- and low-frequency unit with a high quality speaker cable.
WARNING Don’t try to mount the System Don’t try to mount the System C8-C alone. The weight is too much for a single person. You alone. The weight is too much for a single person. You need at least two persons t need at least two persons to build up the system.
Switch off the power amplifiers and disconnect all cables of the C8-C. Pull off C8-C from the base (3). Take care not to touch the diaphragm of the coax from the base (3). Take care not to touch the diaphragm of the coax from the base (3).
Switch (8) in position AUS (Hemisphere) · One-Point-Source with homogenous hemisphere diversity Cleaning Clean the enclosure and stand of the ASCENDO C8-C with a dry and soft cloth. Don’t use water or other chemicals. Don’t touch the tweeter and the woofer.
Need help?
Do you have a question about the C8-C and is the answer not in the manual?
Questions and answers