Troubleshooting - Reliable Enviromate E5 Instruction Manual

REPLACEMENT & OPTIONS
#EA30N
#EA30B
#EA30SS
#EA60N
#EADRAIN
#EAEXT
#EABNOZZLE
#EAWALL
#EACLOTH2
#JTPOWDER
Other accessories are available by contacting your retailer or visiting
www.reliablecorporation.com.

TROUBLESHOOTING

Do not operate the steam cleaner with a damaged cord, plug or if the steam cleaner
has been dropped or damaged. To avoid risk of electric shock, do not disassemble
or attempt to repair the unit on your own. Return the unit to Reliable Corporation
(see warranty) for examination, repair or replacement.
PROBLEM
No steam is released through
the steam fittings.
Drops of water leak from the
attachments.
Dirty water is coming out.
Not enough steam pressure.
Pump is not stopping.
Nylon brush
Brass brush
Stainless steel brush (not supplied with steam cleaner)
60 mm nylon brush
Drain cleaner
Extension
Bent nozzle
Wallpaper remover
Replacement cloths (2/pack)
Cleaning powder
POSSIBLE CAUSES
1. Steam unit is not turned on.
2. Water tank is empty.
3. Unit is not plugged in.
4. Generator is not fully
heated.
1. Unit is not fully heated.
2. Condensation was created
from non-use.
1. Scale may have built up.
1. The dial on the handle may
be set too low.
1. An air (bubble) may be in
the pump.
REMEDy
1. Turn steam unit onto the
2nd position.
2. Put required amount of
water into tank.
3. Plug unit into outlet.
4. Wait for light (3) to turn on.
1. Wait for light (3) to turn on.
2. Let water run through sys-
tem until steam comes out.
1. Follow cleaning instructions
in book.
1. Turn the dial until the desired
pressure is reached.
1. Press the switch on the
steam handle. Hold for a
few seconds until the pump
is primed.
10